It is completely different to use a stand-up lift truck as opposed to a sit-down model. The way you transport and pick up loads as well as your movements are completely different. If you do not have correct training for utilizing a stand-up model, you can possibly cause harm to yourself or to co-workers. When using a stand-up model, you need to follow the proper safety regulations. There are some basic operating standards that must be met when using a stand-up unit.
To start on a stand-up model lift truck, it is important to get a good feel for the controls and the steering knob. As opposed to a steering wheel, the steering is handled using the knob steering plate. Remember that this knob moves really fast, therefore, you should get used to moving it carefully so as to be sure not to over steer. The horn is situated on the control handle, as is the control for forwards, backwards and the movement of the forks. The floor pedal allows the machine to move.
Turn the key to start the forklift's engine when you are set to begin. The forks should be retracted at this stage. When you are moving around the floor, the forks must be pointed a little upwards. Do not drive with extended forks. If you are moving forward, move the control handle forward and step on the pedal to make the lift move forward. If you are backing up, be sure to beep your horn to alert people around you. Look behind you before stepping on the pedal so as to make sure the path is clear and safe. Then, pull the control handle towards you while stepping on the pedal. Stay focused and alert and make sure that you are always operating in a safe manner.
When it comes to turning corners, turn your steering knob in the direction you need to go while keeping your hand on the control handle and your foot on the power pedal. When turning right, the steering knob would move in a clockwise direction during forward travel. If you are turning left, your steering knob will go in a counter-clockwise direction.
If you have only utilized sit down models, the stand-up versions can take some getting used to. If you take some time to figure out the machine and with some training, you will be able to efficiently and quickly handle loads in little time.